Mining machinery operating procedures

The machine is allowed to be put into production after the test run is fully qualified. In order to ensure the long-term safe operation of the machine, special attention should be paid to the correct operation, routine maintenance and regular maintenance of the machine.

1. Preparation before the machine is running:

The machine must be fully prepared and rigorously inspected before starting normal operation. All parts of the machine must be intact. All fixing bolts and anchor nuts should be firmly tightened. Machine accessories must not interfere with the operation and Sundries.

2. The normal operation of the machine:

After the machine is running normally, the operator of the machine and the relevant personnel must pay attention to the following:

(1) Whether all fixing bolts are broken or loose.

(2) Whether the lubrication condition of each bearing is normal and whether there is oil leakage.

(3) Whether the seals are tight everywhere and whether there is oil leakage.

(4) Whether there is excessive phenomenon in the feed amount, and whether the discharge granularity meets the requirements.

(5) Whether the operation of the rolls and gears is normal.

3. Other notes:

1. Do not change the direction of rotation of the machine.

2. When the machine is out of power, the power should be disconnected immediately to avoid accidents caused by sudden calls.

This CLJ60S cable blower set possesses the item number of 20401. It is extensively used for the construction of long-distance communication cable. For blowing once, the length of cable generally ranges from 1000 to 2000 meters.

The complete set is mainly composed of the cable blower, Hydraulic Pump Station, airproof piston, cable seal ring, the sealing ring for plastic pipe, and other parts. The air compressor which provides the set with compressed air should be purchased additionally by our users. Other basic configurations of our Cable Blower Set include a set of GDJ150 pipeline sealing detection device, as well as a set of related sealing elements according to the specification of silicon core pipe and outer diameter of cable that our clients can designate.


9

Optical Fiber Cable Stringing Equipment

Radial Locking Grip, Cable Mesh Sock Grip, Anti Twist Running Board, Special Block For OPGW, Cable Blower Set

NINGBO MARSHINE POWER TECHNOLOGY CO., LTD. , http://www.marshine-power.com

This entry was posted in on